core

CPU: 1T8051, which is 10 times faster than the traditional 8051.

Compatible with 8051 instruction set and dual DPTR working mode.

CPU frequency: higher to support 27MHz.

storage

ROM: Flash: 8K bytes, supporting repeated erasing.

Flash can be divided into program space and data space. The data space can be used to store data that needs to be saved when power is off, and EEPROM can be omitted.

RAM:256 bytes of internal RAM and 2K bytes of external ram.

operating voltage

Working voltage: 1.8-5.5V

Interrupt system

15 active interrupt sources

Two-level interrupt priority supports interrupt nesting.

10 external interrupt sources, and each external interrupt can be configured with any signal pin as an interrupt input pin.

Clock system

Built-in low-speed RC oscillator: 131KHz

Built-in PLL: The frequency multiplier is 2-10 times, and the reference clock is 2-4MHz. Built-in RC oscillator.

Built-in high-speed RC oscillator: 2-4MHz, the accuracy can reach 1% (factory initial frequency is 3.6864 MHz @ 3.3V/25℃).

RTC function

Built-in RTC module can count time, minutes, seconds, weeks and days, and support alarm clock function.

Support millisecond, half-second interrupt

General purpose input/output port (GPIO)

Supports up to 14 GPIO ports.

Support push-pull, open drain, strong pull-up, weak pull-up, strong pull-down, weak pull-down and high resistance modes.

In push-pull mode, different driving intensities and flipping speeds can be set.

timer

Three 16-bit universal timers: Timer 0, Timer 1 and Timer 2.

watchdog

27-bit watchdog timer, 16-bit precision adjustment, configurable watchdog reset or interrupt.

Synchronous/asynchronous communication interface (UART)

Supports up to 2 UART interfaces (different models will be different)

Support 1 byte receive cache

I2C interface

Built-in I2C interface supports master-slave mode and standard/fast/high-speed mode.

I2C can be set with digital filtering to enhance its anti-interference performance.

Analog/digital converter (ADC)

Supports 5-channel 12-bit ADC

Supports three reference sources: VDD, internal reference and external reference.

The VDD voltage can be measured when the internal voltage is selected as the reference voltage.

PWM

6-channel PWM is supported, and the cycle and duty ratio can be configured arbitrarily within the 16-bit range (different models will be different).

It supports complementary mode and dead-time control, and can be used to drive DC brushless motor.

Supports the setting of edge alignment and center alignment modes.

Support the function of directly outputting internal clock.

Support PWM interrupt

Touch Key

Built-in touch sensing controller

Greater support for 11-channel touch

Touch can set internal charging and internal reference, which can effectively suppress low-frequency interference of power supply.

Built-in waterproof compensation mechanism

High anti-interference, in line with EMC(CS) standards.

Support touch power saving mode, lower power consumption is less than 10uA.

Low voltage detection (LVD)

Configurable voltage detection range is 1.8-4.8V

Low voltage reset or interrupt can be set.

Reset mode

The chip supports a variety of reset sources: hard reset, soft reset, watchdog reset, low voltage detection reset, power-on and power-off reset.

low power consumption

STOP mode, current < 7uA

IDLE mode, current < 12uA.

Low speed operation mode, current < 20uA.

Program download and simulation

Support ISP and IAP

Support online simulation function

Package type: SOP16

For detailed information, please call 86）18823661714 (same as WeChat).